Walk-in Chillers
Positive-temperature rooms for dairy, sweets, produce, cooked food and beverages held between +2 °C and +8 °C.
- +2 to +8 °C
- PUF panels
- Hinged / sliding door
A cold room is a project, not a product. We size the room, select the panels and refrigeration system, install it on site and commission it to temperature — for dairies, ice-cream units, food processors, hotels and pharma stores across India.
From a small walk-in chiller behind a sweet shop to a multi-zone cold storage facility.
Positive-temperature rooms for dairy, sweets, produce, cooked food and beverages held between +2 °C and +8 °C.
Minus-temperature storage for frozen food, ice cream and raw material, with the panel thickness and unit matched to the load.
Controlled temperature and humidity chambers for banana, mango and other fruit ripening, with ventilation control.
Rapid freezing for ice cream, meat and prepared food — locks in texture and extends shelf life before transfer to storage.
Insulated PUF panels, doors, fittings and flooring for new rooms — or to repair and extend an existing one.
Refrigeration systems from −86 °C to +22 °C, with low-profile evaporators and energy-efficient condensing units.
The most common cold-room mistake is sizing for the product rather than for the load — how much goes in, how warm it arrives and how fast it has to come down. We work from those numbers, not just the room's dimensions.
Final set points depend on your product and process — confirmed at design stage.
No two rooms are the same, so we do not sell cold rooms off a price list. Every project starts with what goes in, how much, and how cold it has to stay.
Book a site surveyWe look at the space, power supply, drainage and access before quoting anything.
Product load, turnover and temperature decide panel thickness, unit capacity and layout.
PUF panels, doors, condensing units, evaporators and controls, delivered to site.
Assembled, piped, wired and run to temperature, with a handover walkthrough.
Preventive checks, gas and controls support to keep the room holding temperature.
Dairy and ice cream lead our project work, but the same engineering applies across food and pharma.
Small walk-in rooms are usually completed in a couple of weeks once the design is approved and panels are in. Larger multi-zone rooms depend on civil work and equipment lead times — we will give you a schedule with the quote.
Yes. We supply replacement panels, doors, evaporators and condensing units, and can retrofit controls or repair insulation on rooms built by others.
We handle the refrigeration wiring and controls. Dedicated power points, cabling from the meter and any civil work are coordinated with your electrician or contractor — we will specify exactly what the room needs.
We offer preventive maintenance and AMC for cold rooms — coil cleaning, refrigerant checks, control calibration and door and panel inspection.
Visi coolers, deep freezers and supermarket display.
Glass-top freezers, kitchen refrigeration and water coolers.
Professional refrigeration plus bakery, coffee and kitchen equipment.
Battery-powered ice-cream vending carts, 50–120 L.
Share the room size, product and temperature you need — we will come back with a design and a project quote.